SOLIDline X01 Radio

Electronic tubular motor Ø 45 mm with radio

Downloads

The motor is suitable for these applications

The engine has the following features:

Anti-freeze protection

The motor detects that the blind is frozen to the windowsill and stops the rolling-up process.

Delayed learning

The motor does not learn its actual end positions until the fifth driving cycle.

GEIGER Radio 2.0

The unidirectional radio system offers a long range and enables secure communication with remote receivers.

Obstacle detection in the UP direction

The built-in motor intelligence detects obstacles during retraction, thereby protecting the system.

Operation

The motor can be operated using a remote control or, alternatively, via a control switch (wired).

Plug & Play

Automatic detection of end positions without time-consuming adjustment during installation. Completed in just one up and down cycle. Quick and precise adjustment of end positions.

Referencing

Every 50 cycles, a reference run is performed to verify that the end positions are correct. To do this, the curtain is raised until the motor cuts out due to torque. The end positions are checked in this way and, if necessary, readjusted.

Soft position

The blind stops before reaching the top position to protect the materials.

Synchronization position

Consistent stopping behavior is always guaranteed, even with roller shutters of varying widths or heights. No more roller shutters hanging at different heights in the fully raised position.

Product advantage

  • Electronic limit switch
  • Automatic detection left/right installation
  • Can be wired in parallel
  • Plug-in connection cable available in various lengths
  • Already in learning mode on delivery

Notes

  • Do not use a switch with simultaneous UP/DOWN command
  • Rigid shaft connection and stopper absolutely necessary
  • Adjustment of end positions possible via operating switch

Options

  • Available with SOC or COM head
  • Available as a high-speed model upon request

Limit switch adjustment

Above

Full stop*

Below

Full stop*

* For roller shutters with stopper and anti-lift device / rigid shaft connection

Possible cylinder heads

SOC head
COM head

Technical data tubular motor SOLIDline with SOC head

SOLIDline SOC head
SOLIDline COM head
GU45__-F12 GU4510-F12 GU4520-F12 GU4530-F12 GU4540-F12 GU4550-F12
Voltage 230 V~/50 Hz
Electricity 0,47 A 0,63 A 0,80 A 1,00 A 1,00 A
Cos Phi >0,95
Inrush current (factor) x 1,2
Performance 105 W 140 W 180 W 220 W 220 W
Torque 10 Nm 20 Nm 30 Nm 40 Nm 50 Nm
RPM 16 rpm 16 rpm 16 rpm 16 rpm 12 rpm
Final switch-off range > 200 revolutions
Protection class IP44
Total length¹ 519.5 mm 549.5 mm 569.5 mm 589.5 mm 589.5 mm
Operating mode S2 4 min. S2 5 min. S2 4 min. S2 4 min. S2 4 min.
Sound pressure level² 39 dB(A) 41 dB(A) 41 dB(A) 43 dB(A) –
diameter 45 mm
Radio frequency 433 MHz
Weight ca. 1,9 kg ca. 2,2 kg ca. 2,4 kg approx. 2.7 kg approx. 2.7 kg
Ambient humidity dry, non-condensing
Storage temperature T = -15°C … +70°C
¹ With COM head + 0.5 mm
² The information on the average sound pressure level is for guidance only. The values were recorded at GEIGER at idle speed with the drive suspended freely at a distance of 1 m and averaged over 10 seconds. The measurement does not refer to any specific test standard.
Subject to technical changes.