SOLIDline Easy Radio

Electronic tubular motor, Ø  45  mm, with radio control

Downloads

The motor is suitable for these applications

The engine has the following features:

Anti-freeze protection

The motor detects that the blind is frozen to the windowsill and stops the rolling-up process.

Burglar-resistant

By maintaining a constant torque cutoff in the down direction, the roller shutter can effectively deter break-ins (this is only possible for roller shutters equipped with anti-lift devices).

GEIGER Radio 2.0

The unidirectional radio system offers a long range and enables secure communication with remote receivers.

Obstacle detection in the UP direction

The built-in motor intelligence detects obstacles during retraction, thereby protecting the system.

Operation

The motor can be operated using a remote control or, alternatively, via a control switch (wired).

Referencing

Every 50 cycles, a reference run is performed to verify that the end positions are correct. To do this, the curtain is raised until the motor cuts out due to torque. The end positions are checked in this way and, if necessary, readjusted.

Soft position

The blind stops before reaching the top position to protect the materials.

Synchronization position

Consistent stopping behavior is always guaranteed, even with roller shutters of varying widths or heights. No more roller shutters hanging at different heights in the fully raised position.

Product advantage

  • Electronic limit switch
  • Automatic detection left/right installation
  • Can be wired in parallel
  • Plug-in connection cable available in various lengths

Notes

  • The limit positions can be programmed using any control cable. Any control cable that has a programming button or supports simultaneous UP/DOWN commands can be used.
  • Do not use a switch during operation that allows simultaneous UP/DOWN commands, to prevent the learning mode from being activated accidentally.

Options

  • Available with SOC or COM head
  • Available as a high-speed model upon request

Limit switch adjustment

Above

Auf Position

Full stop*

Below

Auf Position

Full stop*

* For roller shutters with stopper and anti-lift device / rigid shaft connection

Possible cylinder heads

SOC head
COM head

Technical data tubular motor SOLIDline with SOC head

SOLIDline SOC head
SOLIDline COM head
>
GU45__F11GU4510F11GU4520F11GU4530F11GU4540F11GU4550F11
Voltage230 V AC / 50 Hz
Electricity0,47 A0,63 A0,80 A1,00 A1,00 A
Cos Phi>0,95
Inrush current (factor) × 1.2
Performance105 W140 W180 W220 W220 W
Torque10 Nm20 Nm30 Nm40 Nm50 Nm
RPM16 rpm16 rpm16 rpm16 rpm12 rpm
Limit switch range200 revolutions
Protection rating IP44
Total length¹519.5 mm549.5 mm569.5 mm589.5 mm589.5 mm
Operating modeS2 4 min.S2 5 min.S2 4 min.S2 4 min.S2 4 min.
Sound pressure level²39 dB(A)41 dB(A)41 dB(A)43 dB(A)–
Durchmesser45 mm
Radio frequency433 MHz
Weightapprox. 1.90 kgapprox. 2.20 kgapprox. 2.40 kgapprox. 2.70 kgapprox. 2.70 kg
Ambient humidity dry, non-condensing
Storage temperatureT = -15°C .. +70°C
¹ With COM head + 0.5 mm
² The information on the average sound pressure level is for guidance only. The values were recorded at GEIGER at idle speed with the drive suspended freely at a distance of 1 m and averaged over 10 seconds. The measurement does not refer to any specific test standard.
Subject to technical changes.