XS5606 SoftPerfection-X01

XS5606 SoftPerfection-X01

Electronic tubular motor Ø 56 mm

Downloads

The motor is suitable for these applications

The engine has the following features:

Anti-freeze protection

The motor detects that the blind is frozen to the windowsill and stops the rolling-up process.

Delayed learning

The motor does not learn its actual end positions until the fifth driving cycle.

Obstacle detection in the UP direction

The built-in motor intelligence detects obstacles during retraction, thereby protecting the system.

Plug & Play

Automatic detection of end positions without time-consuming adjustment during installation. Completed in just one up and down cycle. Quick and precise adjustment of end positions.

Referencing

Every 50 cycles, a reference run is performed to verify that the end positions are correct. To do this, the curtain is raised until the motor cuts out due to torque. The end positions are checked in this way and, if necessary, readjusted.

Soft position

The blind stops before reaching the top position to protect the materials.

Synchronization position

Consistent stopping behavior is always guaranteed, even with roller shutters of varying widths or heights. No more roller shutters hanging at different heights in the fully raised position.

Product advantage

  • Electronic limit switch
  • Automatic detection left/right installation
  • Can be wired in parallel
  • Plug-in connection cable available in various lengths
  • Already in learning mode on delivery

Notes

  • Rigid shaft connectors and stoppers are absolutely essential
  • Adjustment of the end position possible via operating switch
  • Do not use a switch during operation that allows simultaneous UP/DOWN commands, to prevent the learning mode from being activated accidentally.

Limit switch adjustment

Above

Full stop*

Below

Full stop*

* For roller shutters with stopper and anti-lift device / rigid shaft connection

Technical data tubular motor SOLIDline with SOC head

XS5606 SOC head
XS5606-E16
Insert Roller shutter with 60 mm 8-edge shaft (> 370 mm), shaft material < 0.6 mm
Voltage 230 V~/50 Hz
Current 0,4 A
Cos Phi >0,95
Inrush current (factor) x 1,2
Power 93 W
Torque 6 Nm
Speed 26 rpm
Final switch-off range > 200 revolutions
Protection class IP54
Overall length 316.7 mm
Operating mode S2 4 min.
Sound pressure level¹ 34 dB(A)
Diameter 55 mm
weight approx. 1.5 kg
Ambient humidity dry, non-condensing
Storage temperature T = -15°C … +70°C
¹ The information on the average sound pressure level is for guidance only. The values were recorded at GEIGER at idle speed with the drive suspended freely at a distance of 1 m and averaged over 10 seconds. The measurement does not refer to any specific test standard.
Subject to technical changes.