SOLIDline SoftPerfection-X01

Electronic tubular motor Ø 45 mm

Downloads

The motor is suitable for these applications

The engine has the following features:

Anti-freeze protection

The motor detects that the blind is frozen to the windowsill and stops the rolling-up process.

Delayed learning

The motor does not learn its actual end positions until the fifth driving cycle.

Obstacle detection in the UP direction

The built-in motor intelligence detects obstacles during retraction, thereby protecting the system.

Plug & Play

Automatic detection of end positions without time-consuming adjustment during installation. Completed in just one up and down cycle. Quick and precise adjustment of end positions.

Referencing

Every 50 cycles, a reference run is performed to verify that the end positions are correct. To do this, the curtain is raised until the motor cuts out due to torque. The end positions are checked in this way and, if necessary, readjusted.

Soft position

The blind stops before reaching the top position to protect the materials.

Synchronization position

Consistent stopping behavior is always guaranteed, even with roller shutters of varying widths or heights. No more roller shutters hanging at different heights in the fully raised position.

Product advantage

  • Electronic limit switch
  • Automatic detection left/right installation
  • Can be wired in parallel
  • Plug-in connection cable available in various lengths
  • Already in learning mode on delivery

Notes

  • Do not use a switch with simultaneous UP/DOWN command
  • Rigid shaft connectors and stoppers are absolutely essential
  • Adjustment of the end position possible via operating switch

Options

  • Available with SOC or COM head
  • Available as a high-speed model upon request

Limit switch adjustment

Upper end position

Full stop*

Lower end position

Full stop*

* For roller shutters with stopper and anti-lift device and rigid shaft connection

Possible cylinder heads

SOC head
COM head

Technical data tubular motor SOLIDline with SOC head

SOLIDline SOC head
SOLIDline COM head
GU45__-E03 GU4510-E03 GU4520-E03 GU4530-E03 GU4540-E03 GU4540-E03
Voltage 230 V~/50 Hz
Electricity 0,47 A 0,63 A 0,80 A 1,00 A 1,00 A
Cos Phi >0,95
Inrush current (factor) x 1,2
Performance 105 W 140 W 180 W 220 W 220 W
Torque 10 Nm 20 Nm 30 Nm 40 Nm 50 Nm
RPM 16 rpm 16 rpm 16 rpm 16 rpm 12 rpm
Final switch-off range > 200 revolutions
Protection class IP44
Total length¹ 519.5 mm 549.5 mm 569.5 mm 589.5 mm 589.5 mm
Operating mode S2 4 min. S2 5 min. S2 4 min. S2 4 min. S2 4 min.
Sound pressure level² 39 dB(A) 41 dB(A) 41 dB(A) 43 dB(A) –
diameter 45 mm
Weight ca. 1,9 kg ca. 2,2 kg ca. 2,4 kg approx. 2.7 kg approx. 2.7 kg
Ambient humidity dry, non-condensing
Storage temperature T = -15°C … +70°C
¹ With COM head + 0.5 mm
² The information on the average sound pressure level is for guidance only. The values were recorded at GEIGER at idle speed with the drive suspended freely at a distance of 1 m and averaged over 10 seconds. The measurement does not refer to any specific test standard.
Subject to technical changes.